[Discontinued] Arducam 5MP OV5647 Camera Module with IR Cut and LED for Jetson Nano

Item Description

As part of Project Jetvariety, which allows any camera modules to be connected to the high-speed CSI-2 connector on the Jetson Nano. Arducam released this OV5647 camera module for Jetson Nano. It is designed for both daylight and night vision photography with build-in IR cut filter and two infrared LED illuminator boards. The IR cut filter and the infrared LEDs are automatically ON/OFF according to the light condition and it can be widely used in wild life photography, agriculture NDVI applications and etc.

Features

• Shutter Type: Rolling Shutter
• Color Type: Color
• Interface: MIPI
• Format: RAW Bayer

Specification

• Sensor type: OV5647
• Pixel size: 1.4 x 1.4 um
• Resolution: 5MP 2592x1944
• Optical Size: 1/4inch
• Lens spec: Focal length: 2.25mm，FOV: Horizontal 105 degree，Fixed Focus: 30 cm to infinity
• Frame rate: 30fps@1080p, 90fps@VGA
• Interface Type: 2-Lane MIPI
• Output format: RAW10

Driver Features

• Support Gray, Y10, Y16
• Support RAW8/10 bayer format
• Support Standard V4L2 framework, Video Nodes and Controls (Exposure, Gain and depending on camera parameters)
• Support Single Line Driver Installation Command
• Support OpenCV Friendly and Provides Source Code Demonstration

Applications

• Smart robots
• Wide life Photograph
• Agriculture NDVI

Documentation

• Arducam MIPI Cameras for Jetson Nano
• Assemble Guide
• OV5647 Datasheet

Package Including

• 1pcs OV56547 IR-CUT Camera
• 1pcs Arducam Adapter Board for Jetson Nano
• 2pcs Infrared LED Board
• 2pcs heat sink
• 1pcs 15cm (5.9 inch) flat ribbon cable 15pin 1.0mm pitch to 15 pin 1.0mm pitch
• 1pcs 15cm (5.9 inch) flat ribbon cable 15 Pin 1.0mm pitch to 22 pin 0.5mm pitch
• Acrylic case for the camera module

Software Links

Arducam Jetson Nano Camera Modules

Video Demo