Item Description
As part of Project Jetvariety, which allows any camera modules to be connected to the high-speed CSI-2 connector on the Jetson Nano. Arducam released this OV5647 camera module for Jetson Nano. It is designed for both daylight and night vision photography with build-in IR cut filter and two infrared LED illuminator boards. The IR cut filter and the infrared LEDs are automatically ON/OFF according to the light condition and it can be widely used in wild life photography, agriculture NDVI applications and etc.
Features
- Shutter Type: Rolling Shutter
- Color Type: Color
- Interface: MIPI
- Format: RAW Bayer
Specification
- Sensor type: OV5647
- Pixel size: 1.4 x 1.4 um
- Resolution: 5MP 2592x1944
- Optical Size: 1/4inch
- Lens spec: Focal length: 2.25mm，FOV: Horizontal 105 degree，Fixed Focus: 30 cm to infinity
- Frame rate: 30fps@1080p, 90fps@VGA
- Interface Type: 2-Lane MIPI
- Output format: RAW10
Driver Features
- Support Gray, Y10, Y16
- Support RAW8/10 bayer format
- Support Standard V4L2 framework, Video Nodes and Controls (Exposure, Gain and depending on camera parameters)
- Support Single Line Driver Installation Command
- Support OpenCV Friendly and Provides Source Code Demonstration
Applications
- Smart robots
- Wide life Photograph
- Agriculture NDVI
Documentation
Package Including
- 1pcs OV56547 IR-CUT Camera
- 1pcs Arducam Adapter Board for Jetson Nano
- 2pcs Infrared LED Board
- 2pcs heat sink
- 1pcs 15cm (5.9 inch) flat ribbon cable 15pin 1.0mm pitch to 15 pin 1.0mm pitch
- 1pcs 15cm (5.9 inch) flat ribbon cable 15 Pin 1.0mm pitch to 22 pin 0.5mm pitch
- Acrylic case for the camera module
Software Links
Arducam Jetson Nano Camera Modules
Video Demo