Most 3D models take more than a few hours to print, so you may wish to leave the 3D printer at some point in the printing process. Using an Arducam camera to monitor 3D printing can make you pay close attention to your creation. Since most cameras are not made specifically for the use of 3D printing software, it is impossible to obtain proper support from the manufacturer. Fortunately, Arducam can help you solve all installation and setup problems.
For more details, please refer to our Doc page: https://www.arducam.com/docs/cameras-for-raspberry-pi/native-raspberry-pi-cameras/how-to-use-arducam-motorized-focus-camera-with-octopi-to-monitor-3d-printers/
| Sensor | Omnivision OV5647 sensor |
| Optical Size | 1/4” (OV5647) |
| Resolution | 5MP 2592×1944 |
| Frame Rates | 1080p 30 fps, 720p 60fps, 480p 90fps |
| Focus Distance | 2” to infinity |
| Field of View(FOV) | 64°(H), 48°(V) |
| Focus Type | Motorized Focus |
| IR Sensitivity | Integral IR filter, visible light only |
| Lens Type | Stock Lens |
| Full-frame SLR lens equivalent | 35mm |
| Dimension | 24mm x 25mm |
| Peaking Current | 300mA |
