UCTRONICS 0.96 Inch OLED Module 12864 128x64 Yellow Blue SSD1306 Driver I2C Serial Self-Luminous Display Board for Arduino Raspberry PI

Only 52 left

This OLED display module is small, only 0.96” diagonal, it is made of 128x64 individual yellow and blue OLED pixels, each one is turn on or off by the controller chip.

The highlight of OLED display is that it is a self light-emitting technology that does not require additional back-light, and the contrast is much higher (black is really black) than LCD display

The Driver chip of this OLED is SSD1306, which is compatible with IIC communication. So this module can be controlled by I2C.

That is, except the VCC and GND, 2 wires would be needed when using 4-wires I2C mode.

There is also a simple switch-cap charge pump that turns 5v into a low voltage drive for the OLEDs, making this module the easiest ways to get an OLED into your project.



OLED self-luminous, no backlight

Size: 0.96”

Driver IC: SSD1306

Voltage: 3.3V-5V DC

Viewing angle: > 160°

High resolution: 128 x 64

Working Temperature: -30°C~70°C

Display: 2 rows of yellow, 6 rows of blue

Module Size: 27mmx 27mm x 4mm

Screen material: glass, need good protection

I2C Interface:

GND: Ground

VCC: 3.3V~5V

SCL: I2C Serial Clock (UNO: A5; MEGA: 21)

SDA: I2C Serial Data (UNO: A4; MEGA: 20)



MP3, MP4, watch

Head-mounted displays

Meters and other intelligent instruments

Design any pretty patterns for your beloved electronic devices!


Package including

1pcs UCTRONICS 0.96 Inch 128X64 Yellow Blue OLED Display Module


Additional Resources

Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account