200mm Sensor Extension Cable for Raspberry Pi Camera Module V2/V3, Support Working on Raspberry Pi and NVIDIA Jetson Nano

Overview

After the release of the Raspberry Pi V2 camera, we designed a unique camera extension cable (B0186) to meet the requirement for camera extension. The extension cable can extend the working distance of the camera and ensure signal transmission.
With the release of the latest Raspberry Pi V3 camera module, we specially made this Sensor Extension Cable adapt to the V3 extension solution.
You just need to remove the connector and reconnect the camera board and the connector with an extension cable. There is no need to install an additional driver.
Meanwhile, this cable is not only compatible with Raspberry Pi V2/V3 cameras but can work directly with Arducam IMX219 cameras. As for platform compatibility, you can also use this cable with IMX219 Camera on Nvidia Jetson Nano.

Features

• Designed for V3: A fresh Arducam design to extend your camera vision on the latest released Raspberry Pi Camera Module V3
• Easy to SetUp: Just need to peel off the sensor from the connector on the camera board and put our cable in between. No additional Driver is needed
• Support V2/V3 and More: Not only work with Raspberry Pi V2/V3 camera. Also compatible with Arducam IMX219 Drop in Replacement cameras
• Flexible Vision: The flexible and narrow cable body allows you to place it in narrow places such as enclosures and holes, saving you space while completing your projects
• Wide Compatibility: Support working with IMX219 and IMX708 image sensors. Compatible with Raspberry Pi and NVIDIA Jetson Nano platforms.

Specifications

Package Including

• 1 x  Arducam 200mm extension cable for Raspberry Pi and Nvidia Jetson Nano Camera Module

Notes

• The Raspberry Pi Camera Module V2/V3 is NOT included in the package.
• The cable is mainly designed for V2/V3 Camera Module. It does NOT support 5MP V1 cameras or any other sensors.
• Please detach and re-attach the connectors gently and carefully, otherwise, you might cause damage to the connection.
• Please Note that a camera board is needed to work with this extension cable

• ★KERNEL CAMERA DRIVER USED

  This camera relies on kernel drivers to work – one kernel version, one camera driver. Note on supported Nvidia Jetson Boards and Jetpack versions, please refer to Supported JetPack Version for Different NVIDIA Jetson Platforms to ensure compatibility.

  ★ SUPPORTED PLATFORM DISCLAIMER

  This camera is specifically designed for the official NVIDIA® Jetson™ Developer Kit by default and does not support third-party carrier boards.

  ★ADDITIONAL ACCESSORY INSTRUCTIONS

  The 22-22 pin FPC Cable is included in the package. But please note that: If you are using an AGX Orin, an additional camera adapter (B0473)  is required.

Supported Cameras

Picture
SKU	V3	V2	B0180	B0181	B0182	B0183	B0184	B0390	B039001	B0392	B0393	B0394	B0395
Sesnor	IMX708	IMX219	IMX219	IMX219	IMX219	IMX219	IMX219	IMX219	IMX219	IMX219	IMX219	IMX219	IMX219
Resolution	12MP	8MP	8MP	8MP	8MP	8MP	8MP	8MP	8MP	8MP	8MP	8MP	8MP
Focus Type	Autofocus	Fixed Focus	Manual Focus	Autofocus	Autofocus	Manual Focus	Manual Focus	Fixed Focus	Fixed Focus	Manual Focus	Autofocus	Manual Focus	Fixed Focus

Documentation

• IMX219 Quick Start
• Arducam Camera Extension Cable Solution

Video

Blog

• Arducam Accessories for Raspberry Pi Camera Module 3
• IMX219 Miniature Camera for NVIDIA Jetson Nano